RADNOR™ .023 - .045" X 1.714" 11 Series Gas Diffuser For RADNOR™ Pro 130 MIG Guns

Features

• Easy identification - part no rolled stamped on the outside surface
• A machined thread is on the outside surface to allow the nozzle assemblies to thread over holding the nozzle in place during the welding process
• Designed to be used with thread on nozzle assemblies
• Machined from 360 brass alloy bar stock to ensure consistent dimensional stability
• Recessed Tips are generally used for higher heat applications where longer electrical stick-out is required, or in cases where the nozzle may touch the work piece (tack, spot, and stitch)
• Flush tips are generally used where a shorter electrical stick-out is used sometimes resulting in shorter/tighter arc lengths, this brings the tip closer to the work piece
• Protruding Tips are generally used when welding open root pipe or any joint that requires the welder to get into a tight weld joint
• However the down side to this is the chance of arcing the tip to the work piece, which could damage front end parts resulting in downtime needed to replace